ep

January 22, 2021

SMR Gearbox Set up
Satisfactory functionality will depend on suitable installation. lubrication and upkeep. consequently it is crucial the directions in the set up and upkeep leaflet. provided with each gearbox. are followed very carefully. several of the critical aspects of belt and torque-arm set up are listed below.
1. Install pulley on gearbox input shaft as shut towards the reducer doable, and mount reducer on driven shaft as near to bearing as sensible. failure to do this can bring about extra loads during the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive together with the belt pull at roughly 90° to the center line between driven and input shafts. this may allow tensioning of your wedge belt drive using the torque arm which should preferably be in stress. if output hub runs anti-clockwise. torque arm must be positioned the right.
3. lnstall torque-arm fulcrum on the rigid support to ensure that the torque-arm will likely be at roughly ideal angles to the center line through the driven shaft and the torque arm case bolt. be sure there exists ample consider up while in the turnbuckle for belt stress adjustment.
Continue to keep close.
Bell drive may be found in any hassle-free postion. if your torque arm is usually to be utilized to tighten the belts, the drive need to be at about tight angle to your line among the input and output shafts.
Bell drive may very well be found towards the correct if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that proven in the illustration.
Torque arm and belt take up.
Torque arm could possibly be mounted to the proper if desired.